AUTOR DO BLOG ENG.ARMANDO CAVERO MIRANDA SÃO PAULO BRASIL

"OBRIGADO DEUS PELA VIDA,PELA MINHA FAMILIA,PELO TRABALHO,PELO PÃO DE CADA DIA,PROTEGENOS DO MAL"

"OBRIGADO DEUS PELA VIDA,PELA MINHA FAMILIA,PELO TRABALHO,PELO PÃO DE CADA DIA,PROTEGENOS  DO MAL"

“SE SEUS PROJETOS FOREM PARA UM ANO,SEMEIE O GRÂO.SE FOREM PARA DEZ ANOS,PLANTE UMA ÁRVORE.SE FOREM PARA CEM ANOS,EDUQUE O POVO.”

“Sixty years ago I knew everything; now I know nothing; education is a progressive discovery of our own ignorance. Will Durant”

https://picasion.com/
https://picasion.com/

quarta-feira, 27 de dezembro de 2023

Development of Magnetic Models to Assess Transformers’ Susceptibility to Geomagnetic Disturbances A thesis submitted to The University of Manchester for the degree of Doctor of Philosophy in the Faculty of Science and Engineering


 Development of Magnetic Models to Assess Transformers’ Susceptibility to Geomagnetic Disturbances A thesis submitted to The University of Manchester for the degree of Doctor of Philosophy in the Faculty of Science and Engineering 2018
 Yufan Ni 
School of Electrical and Electronic Engineering

 Abstract 
During the peak years of solar activity, the magnetic field held by the solar wind has an impact on the Earth’s magnetic field and induce an electric field on the Earth’s surface. The Geomagnetically Induced Current (GIC) is generated between two neutral points of transformers. The GIC can do severe harm to a power system, including to its transformers. The worst GIC event caused a power system blackout for several hours in Quebec in 1989. The research aims to build a representative model of core saturation and carry out simulation studies to understand the performance of transformer cores in the high flux density region. This in turn helps to identify the design features that need to be taken into account when assessing the capability of a transformer to withstand over-excitation. ATP is a kind of user-maintained software so it allows self-developed code to be added into the software package. The results simulated by the existing ATP models are inaccurate compared to the measured results. In addition, the existing models cannot provide flux distribution results, so it is difficult to understand the process of how the core is pushed into the deep saturation region by DC offset. A new model is developed to include the equivalent electric and magnetic circuit representations, taking flux leakage, in particular, into consideration. The flux leakage paths are composed of the oil gaps and tank in series. This model is validated by the consistency shown between the measured and simulated HV winding currents of a 5-limb transformer. The peaks of magnetising currents are identified with the peaks of magnetic flux which saturate the core. The model can identify the design features, such as the core structure, dimension of flux leakage paths and winding impedance that need to be taken into account when assessing the capability of a transformer to withstand over-excitation. A 3-limb model and a 5-limb core model are built to assess the susceptibility to GIC for different core types in high flux density region. The delta winding plays a role in holding the 3rd harmonics and unbalanced current generated by core saturation, and in delaying the core saturation. Lastly, Transformers are simulated under realistic GIC waveforms, for situations with and without load. The new model is expected to be coded into ATP to conduct a GIC study for a power system.



terça-feira, 26 de dezembro de 2023

Contribution to the DC-AC conversion in photovoltaic systems :Module oriented converters Oswaldo Lopez Santos-THESE En vue de l'obtention du DOCTORAT DE L’UNIVERSITÉ DE TOULOUSE


 Abstract
These last years, a growing interest in power electronic systems has been motivated by the emergence of distributed renewable energy resources and their interconnection with the grid. In this context, the need of low power topologies fed by a few photovoltaic modules avoiding the use of transformers opens the study of special converters and the associated control strategies ensuring stability, reliability and high efficiency. A resulted generic device known in the commercial and scientific literature as “microinverter” or “module integrated converter” performs a plug and play product together with the PV module called an “AC module”. This work is devoted to the study of a transformer-less single-phase double-stage grid-connected microinverter. The proposed topology has a non-isolated high-gain boost type DC-DC converter and a non-isolated buck type DC-AC converter connected in cascade through a DC bus. The DC-DC converter permanently extracts the maximum power of the PV module ensuring at the same time a good performance coping with power changes introduced by the change in the environmental conditions. The DC-AC stage injects the power extracted by the DC-DC stage into the grid ensuring a high level of power quality. The research efforts focus on the involved control functions based on the sliding mode control theory, which leads to a simple implementation with a comprehensive theoretical description validated through simulation and experimental results. After giving the state-of-the-art in the first chapter, the manuscript is divided into four chapters, which are dedicated to the Maximum Power Point Tracking (MPPT), the DC-DC stage and its control, the DC-AC stage and its control and the complete microinverter. A new Extremum Seeking Control (ESC) MPPT algorithm is proposed. The single-switch quadratic boost converter is studied operating as a Loss-Free-Resistor (LFR) obtaining a high DC output voltage level with a safe operation. The full-bridge converter is controlled as a Power Source Inverter (PSI) using a simple sliding-mode based tracking law, regulating the voltage of the DC bus and then ensuring a high power quality level in the grid connection. Finally, the three building blocks are merged to obtain a sliding mode controlled microinverter constituting the main result and contribution of the work.


segunda-feira, 25 de dezembro de 2023

Parfenov K.V. - Quantum theory. Part 2. Lectures - 1. Combining quantum theory and relativism-Парфенов К.В. - Квантовая теория.Часть 2.Лекции - 1. Объединение квантовой теории и релятивизма


 

How did the USSR miss stealth technology? Part 1 P.Yu. Ufimtsev and the edge wave method-Como a URSS perdeu a tecnologia furtiva? Parte 1 P.Yu. Ufimtsev e o método da onda de borda



The discovery that actually enabled the development of the Lockheed F-117, the first truly stealthy aircraft, was achieved by the Russian physicist Pyotr Ufimtsev, who in 1962 published a paper on a new method (not the first) for estimating edge diffraction, which became known as the Physical Theory of Diffraction. Ufimtsev postulated that Maxwell's equations would make it possible to calculate the behavior of radar waves relayed from a reflective object. The radar return would depend in part on the shape of the object.

Probably one of the main achievements of the Soviet era is the enormous development of technical and basic sciences. It is worth saying that during the period 1950–1970, 7 people became Nobel Prize laureates in physics, 1 in chemistry (from 1980 to 2019, only 3, and that’s a stretch). The number of scientific workers in the USSR in 1975 was a quarter (a quarter, Karl) of the scientific workers of the whole world. 

The era of 1950-1970 was marked by brilliant achievements in astronautics, nuclear energy and the aviation industry. It’s the last one I’d like to talk about. Ufimtsev and the edge wave method All this enormous scientific potential often transformed from quantity to quality. So, in 1962, a young scientist, 

P.Ya. Ufimtsev published a monograph “The method of edge waves in the physical theory of diffraction.”



Being familiar with it from a course in electrodynamics, I can say that the reading is quite difficult, but entertaining, and non-specialists in the field of antennas and microwave devices will understand little in it. This book consists of solving diffraction problems on simple bodies and mainly consists of deriving formulas. Here are some, for example:




Example of output of one of the formulas 

 With the help of such calculations, solutions to a number of diffraction problems for a wedge and disk were obtained, and non-uniform parts of the current were found for these bodies. The theory of physical optics existing at that time did not take into account the uneven part of the current, which was concentrated near the kink. To put it more roughly, it turned out to be possible to more accurately describe the further behavior of electromagnetic waves when falling on surfaces with kinks and sharp edges. More accurately predict the structure of scattered waves. It would seem, what does aviation have to do with it?

Stealth aircraft concept Since the mid-20th century, almost all countries have used radar stations to monitor air or water space.



Let's focus only on air. The detection range of an object: an airplane, a helicopter, a seagull or a crow is largely determined by the characteristics of the radar, but there is one characteristic that is inherent to the object - the effective scattering area (ESR). EPR is a quantitative measure of the scattering of an electromagnetic wave. The higher the EPR value, the further away the object can be detected. The EPR is determined by the physical and geometric properties of the object.



The problems solved by Ufimtsev allowed us to formulate the concept of inconspicuous objects. Using such an ideology in the construction of aircraft and knowing the characteristics of enemy radars, it was possible to significantly reduce the detection range. This technology, which will later become evident in Yugoslavia (this will be discussed in Part 2), can provide a huge advantage. Let me remind you that the time of writing the monograph was 1962, the time of the Cuban Missile Crisis and the Cold War. The world was on the brink of war and destruction. The arms race continued and the use of stealth technology could make it possible to take the lead in this race.



However, the Soviet Union did not take the idea seriously. And there are many reasons for this. At that time, the Soviet Union focused on the speed and maneuverability of aircraft (MiG-15, MiG-17). The new concept implied a complete abandonment of these parameters. To build an airplane using stealth technology, it was necessary to reinvent the airplane, just as Steve Jobs later reinvented the telephone. Unfortunately, the USSR is not a country in which any discussion on this matter was possible. The exact reason why the Soviet Union abandoned the development of a low-observability aircraft is unknown. The monograph sold a large circulation of 6,500 copies and it is doubtful that none of the management thought about using this theory. 

 Development in the USA

 Let's move to the USA. At that time, American aircraft could not boast of their power. The first development of a stealth aircraft in the United States began in 1958. However, the attempts were unsuccessful. The planes were much inferior to the Soviet ones, as demonstrated by the Vietnam War. Their basic science lagged behind. They had not heard about the edge wave method until they accidentally (or maybe not) translated Ufimtsev’s monograph in 1971. Having got their hands on the theory, the missing link, they began development. The project received funding of several billion dollars. Lockheed and Northrop, using Ufimtsev’s theory and computer modeling (this was already possible in the USA in 1975), were able to develop in 1983 the first aircraft completely made using Stealth technology (Stealth - cunning) - the F-117 Night Hawk. one of the F-117 developers stated

“Ufimtsev’s contribution to the construction of this aircraft is about 30-40%, that is, a controlling stake.”

Many journalists began to write about the "invisible plane." But this is absolutely incorrect. Firstly, it is visible in the optical range, and secondly, it is inconspicuous in a certain sector of angles for certain radars.

 I will share my calculation, carried out while still at the institute. If you look at the scattering diagram of the F-117, you can see how much lower its frontal RCS is. Thanks to this shape, the aircraft re-radiates most of the energy of electromagnetic waves into the upper hemisphere. In the direction of the radar, the radiation is extremely small. The ESR of the F-117 aircraft when irradiated from frontal and tail angles is reduced to 0.1-0.01 m2, which is approximately 100-200 times less than that of a conventional aircraft of similar sizes.

Pyotr Yakovlevich Ufimtsev, who at that time was working at a research institute in Moscow, did not know anything about the fact that an airplane had been developed in the USA based on his monograph. Imagine his surprise when, in 1990, he went to a conference in the USA by invitation, after finishing his report, the audience gave him a standing ovation, but he could not understand how he had gained such fame. In the USSR he was known to few people. But his monograph became a reference book for Lokcheed Martin engineers. After so many years, he got what he deserved. True, not in my home country. In the 90s, no one in Russia needed scientific personnel, the economic crisis and meager salaries. Ufimtsev goes to work at the University of California at Los Angeles as a visiting professor and participates in the creation of the B2 strategic bomber. Now Ufimtsev is 88 years old and lives in America.




P.Ya. Ufimtsev published a monograph “The method of edge waves in the physical theory of diffraction.” «Метод краевых волн в физической теории дифракции».


VIEW FULL TEXT:

domingo, 24 de dezembro de 2023

Design and characterization of a three-phase current source inverter using 1.7kV SiC power devices for photovoltaic applications Luis Gabriel Alves Rodrigues THÈSE Pour obtenir le grade de DOCTEUR DE LA COMMUNAUTE UNIVERSITE GRENOBLE ALPES Spécialité : Génie Electrique


 








Design and characterization of a three-phase current source inverter using 1.7kV SiC power devices for photovoltaic applications 

Luis Gabriel Alves Rodrigues 

 THÈSE Pour obtenir le grade de DOCTEUR DE LA COMMUNAUTE UNIVERSITE GRENOBLE ALPES Spécialité : Génie Electrique 

 Abstract

 Classically, the energy conversion architecture found in photovoltaic (PV) power plants includes solar arrays delivering a maximum voltage of 1kV followed by a step-up chopper connected to a three-phase Voltage Source Inverter. This multistage conversion system (DC/DC + DC/AC) is then connected to the medium-voltage grid through a low-voltage/medium-voltage transformer. In order to simplify the PV systems, this research work focuses on the study and implementation of a DC/AC topology employing a single power processing stage: the three-phase Current Source Inverter (CSI). To deal with the inconvenient of high conduction losses when implementing this topology, wide-bandgap Silicon Carbide (SiC) semiconductors are used, allowing to efficiently convert energy while keeping a relatively high switching frequency. Nonetheless, since the available power semiconductor modules on the market are not compatible with the CSI, a novel 1.7kV SiC-based voltage bidirectional module is developed in the context of this thesis. Hence, the dynamic characterization of the new SiC device is carried out and serves as the basis for the design of a 60kW CSI prototype. Finally, the inverter efficiency is evaluated at nominal operating conditions, employing both a calorimetric and electrical methods. The obtained results confirm the CSI ability to operate efficiently at high switching frequencies (η>98.5% @60kHz). The originality of this work lies mainly in the design, characterization and implementation of the new 1.7kV full-SiC power module adapted to the CSI topology.

 Keywords: Power electronics, DC/AC converters, Current Source Inverter (CSI), Silicon Carbide (SiC), Photovoltaics, Power module.